Toshiba TOSVERT VF-nC3E - Current;Voltage Unit Selection; Example of Setting; Display in Percentage Terms; Display in Amperes;Volts

E6582233
F-64
6
6.20.2 Changing the unit (A/V) from a percentage of current
and voltage
 :Current/voltage unit selection
 Function
These parameters are used to change the unit of monitor display.
%
 A (ampere)/V (volt)
Current 100% = Rated current of inverter
Input voltage 100% = 400Vac
Output voltage 100% = 400Vac
 Example of setting
During the operation of the VFNC3E-4022P (rated current: 5.5A) at the rated load (100% load), units are
displayed as follows:
1) Display in percentage terms 2) Display in amperes/volts

.
 
 
Output current:
5.5A
Input voltage:
400V
Input voltage:
100%
Output current:
100%
%
%
[Parameter setting]
Title Function Ad
j
ustment ran
g
e Default settin
g

Current/voltage unit
selection
0: %
1: A
(
ampere
)
/
V
(
volt
)
0
* The  converts the following parameter settings:
 A display Current monitor display: Load current, torque current
Motor electronic-thermal protection level 1 & 2
, 
DC braking current 
Stall prevention level 1 & 2 , 
Small current detection current 

V display: Input voltage, output voltage
Note) Base frequency voltage 1 & 2(, ) always displayed in the unit of V.