TP-Link T2600G-28TS - Page 127

115
 Configure Switch D:
Step Operation Description
1 Configure ports On VLAN→802.1Q VLAN→VLAN Config page,
configure the link type of the related ports as Tagged,
and add the ports to VLAN101-VLAN
106. The
detailed instructions can be found in the section
802.1Q VLAN.
2 Enable STP function On Spanning Tree→STP Config→STP Config
page, enable STP function and select MSTP version.
On Spanning Tree→STP Config→Port Config
page, enable MSTP function for the port.
3 Configure the region name and
the revision of MST region
On Spanning Tree→MSTP Instance→Region
Config page, configure the region as TP-LINK and
keep the default revision setting.
4 Configure VLAN-to-Instance
mapping table of the MST region
On Spanning Tree→MSTP Instance→Instance
Config page, configure VLAN-to-Instance mapping
table. Map VLAN101, 103 and 105 to Instance 1; map
VLAN102, 104 and 106 to Instance 2.
 The configuration procedure for switch E and F is the same with that for switch D.
 The topology diagram of the two instances after the topology is stable
 For Instance 1 (VLAN101, 103 and 105), the red paths in the following figure are connected
links; the gray paths are the blocked links.
 For Instance 2 (VLAN102, 104 and 106), the blue paths in the following figure are connected
links; the gray paths are the blocked links.