TP-Link T2600G-28TS - 5.4 MAC Address

53
automatically.
Refresh Rate
: Enter a value in seconds to specify the refresh interval.

Port Select
UNIT:
1/LAGS: Click 1 to show the information of the physical ports. Click LAGS
to show the information of the link aggregation groups.
Port:
Enter a port number and click the Select button or select
the port
to view the traffic statistics of the corresponding port.

Statistics
Received
: Displays the details of the packets received on the port.
Sent
: Displays the details of the packets transmitted on the port.
Broadcast
:
Displays the number of good broadcast packets received or
transmitted on the port. The error frames are not counted in.
Multicast
:
Displays the number of good multicast packets received or
transmitted on the port. The error frames are not counted in.
Unicast
:
Displays the number of good unicast packets received or
transmitted on the port. The error frames are not counted in.
Jumbo:
Displays the number of good jumbo packets received or
transmitted on the port. The error frames are not counted in.
Alignment Errors
:
Displays the number of the received packets that have a bad
Frame Check Sequence (FCS) with a non-
integral octet
(Alignment Error). The length of the packet is between 64 bytes
and 1518 bytes.
UndersizePkt
s:
Displays the number of the received packets (excluding error
packets) that are less than 64 bytes long.
Pkts64Octets
:
Displays the number of the received packets (including error
packets) that are 64 bytes long.
Pkts65to127Octets
: Displays the number
of the received packets (including error
packets) that are between 65 and 127 bytes long.
Pkts128to255Octets
:
Displays the number of the received packets (including error
packets) that are between 128 and 255 bytes long.
Pkts256to511Octets
: Displays the
number of the received packets (including error
packets) that are between 256 and 511 bytes long.
Pkts512to1023Octets
:
Displays the number of the received packets (including error
packets) that are between 512 and 1023 bytes long.
Pkts
Over1023Octets: Dis
plays the number of the received packets (including error
packets) that are over 1023 bytes.
Collisions
:
Displays the number of collisions experienced by a port during
packet transmissions.
5.4 MAC Address
The main function of the switch is forwarding the packets to the correct ports based on the
destination MAC address of the packets. Address Table contains the port-based MAC address