TP-Link T2600G-28TS - Profile Binding

168

IP-range Table
Select: Select the desired entry for configuration.
Index: Displays index of the IP-range which is not configurable.
Start IP: Displays the start IP address of the IP-range.
End IP: Displays the
end IP address of the IP-range.
9.2.7 Profile Binding
When the switch receives MLD report message, it examines the profile ID bound to the access
port to determine if the port can join the multicast group. If the multicast IP is not filtered, the switch
will add the port to the forward port list of the multicast group. Otherwise, the switch will drop the
MLD report message. In that way, you can control the multicast groups that users can access.
Choose the menu Multicast→MLD Snooping→Profile Binding to load the following page.
Figure 9-20 Profile Config
The following entries are displayed on this screen:

Profile and Max Group Binding
UNIT:1/LAGS: Click 1 to configure the physical ports. Click LAGS to
configure the link aggregation groups.
Select:
Select the desired port for multicast filtering. It is
multi-optional.