TP-Link T2600G-28TS - VLAN Binding; Policy Binding

241
12.4.3 VLAN Binding
On this page you can bind an ACL to a VLAN.
Choose the menu ACL→ACL Binding→VLAN Binding to load the following page.
Figure 12-16 Bind the policy to the VLAN
The following entries are displayed on this screen:

VLAN-Bind Config
ACL ID: Select the ID of the ACL you want to bind.
VLAN ID: Enter the ID of the VLAN you want to bind.

VLAN-Bind Table
Index: Displays the index of the binding ACL.
ACL ID: Displays the ID of the binding ACL.
VLAN ID: Displays the ID of the VLAN bound to the corresponding ACL.
Direction: Displays the binding direction.
Configuration Procedure:
Step Operation Description
1
Configure ACL rules Required. On ACL→ACL Config
configuration pages,
configure ACL rules to match packets.
2
Bind the ACL
to the
port/VLAN
Required. On ACL→ACL Binding
configuration pages,
bind the ACL to the port/VLAN to make the ACL effective on
the corresponding port/VLAN.
12.5 Policy Binding
Policy Binding function can have the policy take its effect on a specific port/VLAN. The policy will
take effect only when it is bound to a port/VLAN. In the same way, the port/VLAN will receive the
data packets and process them based on the policy only when the policy is bound to the
port/VLAN.
The Policy Binding can be implemented on Binding Table, Port Binding and VLAN Binding
pages.