TP-Link T2600G-28TS - Querier Config

165
Forbidden Router
Ports:
Specify the forbidden router ports which is mainly used to forbid
ports becoming router ports.
Note:
1. The router port should be in the multicast VLAN, otherwise the member ports cannot receive
multicast streams.
2. The Multicast VLAN won't take effect unless you first complete the configuration for the
corresponding VLAN owning the port on the 802.1Q VLAN page.
3. Configure the link type of the router port in the multicast VLAN as Tagged otherwise all the
member ports in the multicast VLAN cannot receive multicast streams.
4. After a multicast VLAN is created, all the MLD packets will be processed only within the
multicast VLAN.
9.2.5 Querier Config
In an IPv6 multicast network that runs MLD, a Layer 3 multicast device works as an MLD querier to
send out MLD queries and manage the multicast table. But MLD is not supported by the devices in
Layer 2 network. MLD Snooping Querier can act as an MLD Router in Layer 2 network. It can help
to create and maintain multicast forwarding table on the switch with the Query messages it
generates.
Choose the menu Multicast→MLD Snooping→Querier Config to load the following page.
Figure 9-18 Querier Config
The following entries are displayed on this screen:

MLD Snooping Querier Config
VLAN ID: Enter the VLAN ID which you want to start Querier.
Query Interval:
Enter the Query message interval time. The Querier
will send General Query Message within this interval.
Max Response Time:
Enter the value of Maximum Response Time of the
Query message.
General Query
Source IP:
Enter the Query Message source IP address.
It is
FE80::02FF:FFFF:FE00:0001 by default.

MLD Snooping Querier List