TP-Link T2600G-28TS - 4.4 Access Security

24
The following entries are displayed on this screen:

Reboot Schedule Setting
Time Interval: Specify a period of time. The switch will reboot after this period.
It ranges from 1 to 43200 minutes.
This reboot schedule recurs if
users check the Save Before Reboot.
Time: Specify the time for the switch to reboot, in the format of HH:MM.
Date: Specify the date for the switc
h to reboot, in the format of
DD/MM/YYYY. The date should be within 30 days. I
f no date is
specified and the time you set here is later than the time that this
above Time is set
, the switch will reboot later that day; otherwise
the switch will reboot at the time point the next day.
Save Before
Reboot:
Select to save the switch’s configurations before it reboots.
Note:
To avoid damage, please don't turn off the device while rebooting.
4.3.7 System Reset
On this page you can reset the switch to the default. All the settings will be cleared after the switch
is reset.
Choose the menu System→System Tools→System Reset to load the following page.
Figure 4-16 System Reset
Note:
After the system is reset, the switch will be reset to the default and all the settings will be cleared.
4.4 Access Security
Access Security provides different security measures for the remote login so as to enhance the
configuration management security. It can be implemented on Access Control, HTTP Config,
HTTPS Config, SSH Config and Telnet Config pages.
4.4.1 Access Control
On this page you can control the users logging on to the Web management page to enhance the
configuration management security.