TP-Link T2600G-28TS - Manual Binding

199
Figure 10-17 Pool Setting
The following entries are displayed on this screen:

DHCP Server Pool

Pool Table
Select: Select the entry to delete the IP pool.
Pool Name: Displays the name of the IP Pool.
Network Address: Displays the network address of the IP Pool.
Subnet Mask: Displays the subnet mask of the IP Pool.
Lease Time: Displays the lease time of the IP Pool.
Operation:
Allows you to view or modify the information of the
corresponding IP Pool.
 Edit: Click to modify the settings of the Pool.
 Detail: Click to get the information of the Pool.
10.4.3 Manual Binding
In this page, you can specify the IP address for specific clients, and then the switch will supply
these specified parameters to them only forever.
Pool Name: Enter the name of the pool.
Network Address: Specify the network number of the IP addresses in the pool.
Subnet Mask:
Specify the corresponding subnet mask of the IP address in the
pool.
Lease Time: Specify the lease time of IP addresses in the pool.
Default Gateway: Specify the IP address of the default gateway for a client.
DNS Server: Specify the IP address of the DNS server for a client.
Netbios Server: Specify the IP address of the Netbios server.
Netbios Node Type: Specify the node type of the Netbios server.
Next Server
Address:
Specify the next DHCP server’s ip address duri
ng the DHCP boot
process.
Domain Name: Specify the domain name of the DHCP client.
Bootfile: Specify the boot file name of the DHCP client.