TP-Link T2600G-28TS - 16.5 Network Diagnostics

337
Pair
: Displays the Pair number.
Status
:
Displays the connection status of the cable connected to the port. The
test results of the cable include normal, close, open or impedance.
Length
: If the connection status is
normal, here displays the length range of
the cable.
Error
:
If the connection status is close, open or impedance, here displays the
error length of the cable.
Note:
1. The interval between two cable tests for one port must be more than 3 seconds.
2. The result is more reasonable when the cable pair is in the open status.
3. The result is just for your information.
16.5 Network Diagnostics
This switch provides Ping test and Tracert test functions for network Diagnostics.
16.5.1 Ping
Ping test function, testing the connectivity between the switch and one node of the network,
facilitates you to test the network connectivity and reachability of the host so as to locate the
network malfunctions.
Choose the menu Maintenance→Network Diagnostics→Ping to load the following page.
Figure 16-6 Ping
The following entries are displayed on this screen:

Ping Config
Destination IP
: Enter the IP address of the destination node for Ping test.
Both IPv4