161
9.2.2 Port Config
On this page you can configure MLD Snooping function with each single port.
Choose the menu Multicast→MLD Snooping→Port Config to load the following page.
Figure 9-15 Port Config
The following entries are displayed on this screen:
Port Config
UNIT:1/LAGS Click 1 to configure the physical ports. Click LAGS to
configure the link aggregation groups.
Select:
Select the port you want to configure.
Port: Displays the port number.
MLD Snooping:
Select Enable/Disable MLD Snooping for the desired
Select Enable/Disable Fast Leave feature for the
desired port. If Fast Leave is enabled for a port, the
s
witch will immediately remove this port from the
multicast group upon receiving MLD done messages.
LAG: Displays the LAG number.
To Next Page
Loading...
