TP-Link T2600G-28TS - Ipv6 Static Routing Config

190

Static Route Table
10.3.2 IPv6 Static Routing Config
Choose the menu Routing→Static Routing→Static Routing Config to load the following page.
Figure 10-10 Static Routing Config
The following entries are displayed on this screen:

Static Routing Config

Static Route Table
Select: Specify the static route entries to modify.
Destination
Address:
Displays the destination IP address of the packets.
Subnet Mask: Displays the subnet mask of the destination IP address.
Next Hop: Displays the IP address to which the packet should be sent next.
Distance: Displays the distance metric of ro
ute. The smaller the distance,
the higher the priority.
Metric: Displays the metric of the route.
Interface Name: Displays the name of the VLAN interface.
IPv6 Address:
Specify the destination IPv6 address of the packets.
Prefix Length: Specify the prefix length of the IPv6 address.
Next Hop: Enter the IPv6 address to which the packet should be sent next.
Distance:
Enter the distance metric of route. The smaller the distance, the
higher the priority.
Select: Select the IPv6 static route entries to modify.
IPv6 Address: Displays the destination IPv6 address of the packets.
Prefix Length: Displays the prefix length of the destination IPv6 address.