TP-Link T2600G-28TS - Serial Port Setting

17
The following entries are displayed on this screen:

DST Config
DST Status: Enable or disable the DST.
Predefined Mode: Select a predefined DST configuration.
 USA: Second Sunday in March, 02:00 ~ First
Sunday in
November, 02:00.
 Australia: First Sunday in October, 02:00 ~ First Sunday
in
April, 03:00.
 Europe
: Last Sunday in March, 01:00 ~ Last Sunday in
October, 01:00.
 New Zealand: Last Sunday in September, 02:00 ~ Fir
st
Sunday in April, 03:00.
Recurring Mode:
Specify the DST configuration in recurring mode. This
configuration is recurring in use.

Offset: Specify the time adding in minutes when Daylight
Saving Time comes.

Start/End Time: Select starting time and ending time of
Daylight Saving Time.
Date Mode: Specify the DST configuration in Da
te mode. This configuration is
recurring in use.

Offset: Specify the time adding in minutes when Daylight
Saving Time comes.

Start/End Time: Select starting time and ending time of
Daylight Saving Time.
Note:
1. When the DST is disabled, the predefined mode, recurring mode and date mode cannot be
configured.
2. When the DST is enabled, the default daylight saving time is of European in predefined mode.
4.1.5 Serial Port Setting
On this page you can configure the Baud Rate of the console connection.
Choose the menu System→System Info→Serial Port Setting to load the following page.
Figure 4-7 User Table