TP-Link T2600G-28TS - 5.3 Traffic Monitor

51
Port Priority:
Specify a Port Priority for the port. This value determines the priority
of the port to be selected as the dynamic agg
regation group
member. The port with smaller Port Priority will be considered as the
preferred one. If the two port priorities are equal; the port with
smaller port number is preferred.
Mode:
Specify LACP mode for your selected port.
Status:
Enable/Disable the LACP feature for your selected port.
LAG:
Displays the LAG number which the port belongs to.
5.3 Traffic Monitor
The Traffic Monitor function, monitoring the traffic of each port, is implemented on the Traffic
Summary and Traffic Statistics pages.
5.3.1 Traffic Summary
Traffic Summary screen displays the traffic information of each port, which facilitates you to
monitor the traffic and analyze the network abnormity.
Choose the menu Switching→Traffic Monitor→Traffic Summary to load the following page.
Figure 5-12 Traffic Summary
The following entries are displayed on this screen:

Auto Refresh
Auto Refresh
: Allows you to Enable/Disable refreshing the
Traffic Summary
automatically.
Refresh Rate
: Enter a value in seconds to specify the refresh interval.