TP-Link T2600G-28TS - TACACS+ Server Config

287
Choose the menu Network Security→AAA→RADIUS Conifg to load the following page.
Figure 13-33 RADIUS Server Config

Configuration Procedure
Configure the RADIUS server’s IP and other relevant parameters under the Server Config.
View, edit and delete the configured RADIUS servers in the Server list.

Entry Description
Server IP
: Enter the IP of the server running the RADIUS secure protocol.
Shared Key
: Enter the shared key between the RADIUS server and the switch.
The RADIUS server and the switch use the key string to encrypt
passwords and exchange responses.
Auth Port
:
Specify the UDP destination port on the RADIUS server for
authentication requests.
Acct Port
:
Specify the UDP destination port on the RADIUS server for
accounting requests.
R
etransmit: Specify the number of times a request is resent to a server if the
server does not respond.
Timeout
: Specify the time interval that the switch waits for the server to reply
before resending.
13.11.4 TACACS+ Server Config
This page is used to configure the authentication servers running the TACACS+ security protocols.