TP-Link T2600G-28TS - Local Log

333
Figure 16-1 Log Table
The following entries are displayed on this screen:

Log Info
Index
: Displays the index of the log information.
Time
: Displays the time when the l
og event occurs. The log can get the
correct time after you configure on the System ->System
Info->System Time Web management page.
Severity
:
Displays the severity level of the log information. You can select a
severity level to display the log information whose severity level value
is the same or smaller.
Content
: Displays the content of the log information.
Note:
3. The logs are classified into eight levels based on severity. The higher the information severity
is, the lower the corresponding level is.
4. This page displays logs in the log buffer, and at most 512 logs are displayed.
16.3.2 Local Log
Local Log is the log information saved in switch. By default, the logs with severities from level_0 to
level_6 are saved in log buffer and the logs with severities from level_0 to level_3 are saved in log
file meanwhile. On this page, you can set the output channel for logs.
Choose the menu Maintenance→Log→Local Log to load the following page.