144
9.1.2 Port Config
On this page you can enable or disable the IGMP Snooping and Fast Leave feature for ports of the
switch.
Choose the menu Multicast →IGMP Snooping →Port Config to load the following page.
Figure 9-6 Port Config
The following entries are displayed on this screen:
Port Config
UNIT:1/LAGS: Click 1 to configure the physical ports. Click LAGS
link aggregation groups.
Select:
Select the desired port for IGMP Snooping feature configuration. It
is multi-optional.
Port: Displays the port of the switch.
IGMP Snooping: Select Enable/Disable IGMP Snooping for the desired port.
Fast Leave:
Select Enable/Disable Fast Leave feature for the desired port. If
Fast Leave is enabled for a port, the switch
will immediately
remove this port from the multicast group upon receiving IGMP
leave messages.
LAG: Displays the LAG number which the port belongs to.
To Next Page
Loading...
