TP-Link T2600G-28TS - Combined ACL

233
TCP Flag
：
Configure TCP flag when TCP is selected from the pull-
down list of IP
Protocol.
S-Port:
Configure TCP/IP source port contained in the rule when TCP/UDP is
selected from the pull-down list of IP Protocol.
D-Port: Configure TCP/IP destination por
t contained in the rule when
TCP/UDP is selected from the pull-down list of IP Protocol.
DSCP: Enter the DSCP information contained in the rule.
IP ToS: Enter the IP ToS contained in the rule.
IP Pre: Enter the IP Precedence contained in the rule.
Time-Range: Select the time-range for the rule to take effect.
12.2.6 Combined ACL
Combined ACLs analyze and process data packets based on a series of match conditions, which
can be the source MAC addresses, destination MAC addresses source IP addresses, destination
IP addresses and other information of this sort carried in the packets.
Choose the menu ACL→ACL Config→Combined ACL to load the following page.
Figure 12-9 Combined ACL
The following entries are displayed on this screen:

Create combined Rule
ACL ID: Select the desired Combined ACL for configuration.
Rule ID: Enter the rule ID.
Operation:
Select the operation for the switch to process packets which match the
rules.
 Permit: Forward packets.
 Deny: Discard Packets.