TP-Link T2600G-28TS - Pool Setting

198

Ping Time Config

Excluded IP Address
Configure the Excluded IP Address which cannot be assigned by the switch.

Excluded IP Address Table
Select: Select the entry to delete the Excluded IP Address pool.
ID:
Displays the corresponding ID of the Excluded IP Address
pool.
Start IP Address: Displays the start IP Address of the Excluded IP Address pool.
End IP Address: Displays the last IP Address of the Excluded IP Address pool.
10.4.2 Pool Setting
This page shows you how to configure the IP pool in which the IP address can be assigned to the
clients in the network.
Choose the menu Routing→DHCP Server→DHCP Server Pool to load the following page.
Option 138:
Configure DHCP option 138. If this option is configured, DHCP
se
rver will response packets containing this option if the client
running CAPWAP protocol request this option.
Ping Packets: The number of packets to be sent.
Ping Timeout: The time it takes to determine the specific IP not exist.
Start IP Address: The first one of the IP addresses that should not be assigned.
End IP Address: The last one of the IP addresses that should not be assigned.