TP-Link T2600G-28TS - Port Config

261
13.3.2 Port Config
Choose the menu Network Security→DHCP Snooping→Port Config to load the following page.
Figure 13-12 DHCP Snooping

DHCP Snooping Port Configuration
UNIT:1/LAGS:
Click 1 to configure the physical ports. Click LAGS
to
configure the link aggregation groups.
Select:
Select your desired port for configuration. It is multi-optional.
Port:
Displays the port number.
Trusted Port:
Select Enable/Disable the port to be a Trusted Port. Only the
Trusted Port can receive the DHCP packets from DHCP
servers.
MAC Verify:
Select Enable/Disable the MAC Verify feature. There are two
fields of the DHCP packet containing the MAC address of the
Host. The MAC Verify feature is to compare the two fields and
discard the packet if the two fields are different.
Ra
te Limit:
Select the value to specify the maximum amount of DHCP
messages that can be forwarded by the switch of this port per
second. The excessive DHCP packets will be discarded.
Decline Protect:
Select the value to specify the maximum amount of DHCP
de
cline packets that can be forwarded by the switch of this
port per second. The excessive DHCP decline packets will be
discarded.