280
The following entries are displayed on this screen:
Enable/Disable the 802.1X function.
Select the Authentication Method from the pull-down list.
• EAP: EAP relay mode. IEEE 802.1X authentication
system uses extensible authentication protocol
(EAP) to exchange information between the switch
and the client. The EAP protocol packets with
n data can be encapsulated in the
advanced protocol (such as RADIUS) packets to be
transmitted to the authentication server.
• PAP: EAP termination mode.
IEEE 802.1X
authentication system uses extensible
authentication protocol (EAP) to exchange
information between the switch and the client. The
transmission of EAP packets is terminated at the
switch and the EAP packets are converted to the
other protocol (such as RADIUS) packets for
Enable/Disable the Handshake feature. The Handshake
feature is used to detect the connection status between
the TP-LINK 802.1X Client and the switch. Please
disable Handshake feature if you are using other client
softwares instead of TP-LINK 802.1X Client.
Enable/Disable the Guest VLAN feature.
Enter your desired VLAN ID to enable the Guest VLAN
feature. The supplicants in the Guest VLAN can access
the specified network source.
Enable/Disable the Quiet timer.
Specify a value for Quiet Period. Once the supplicant
failed to the 802.1X Authentication, then the switch will not
respond to the authentication request from the same
supplicant during the Quiet Period.
Specify the maximum transfer times of the repeated
Specify the maximum time for the switch to wait for the
response from supplicant before resending a request to
the supplicant.
Specify the maximum time for the switch to wait for the
tication server before resending a
request to the authentication server.
13.9.2 Port Config
On this page, you can configure the 802.1X features for the ports basing on the actual network.
To Next Page
Loading...
