TP-Link T2600G-28TS - Ipv6 ACL

234
S-MAC: Enter the source MAC address contained in the rule.
D-MAC: Enter the destination MAC address contained in the rule.
Mask:
Enter IP address mask. If it is set to 1, it must strictly match the
address.
VLAN ID Enter the VLAN ID contained in the rule.
EtherType Enter EtherType contained in the rule.
User Priority
Select the user priority contained in the rule for the tagged packets to
match.
Fragment:
Select if the rule will take effect on the fragment packets. When the
fragment is selecte
d, this rule will process all the fragments and the
last piece of fragment will be always forwarded.
S-IP: Enter the source IP address contained in the rule.
D-IP: Enter the destination IP address contained in the rule.
Mask: Enter IP address mask. If
it is set to 1, it must strictly match the
address.
Time-Range: Select the time-range for the rule to take effect.
Note:
Before binding a Combined ACL to an interface or VLAN, you should configure the SDM template
as “default” or “enterpriseV4” and save your configurations. See SDM Template for more
information about SDM template configuration.
12.2.7 IPv6 ACL
IPv6 ACLs analyze and process data packets based on a series of match conditions, such as the
source IPv6 addresses, destination IPv6 addresses and port number carried in the packets.