TP-Link T2600G-28TS - Page 172

160
Last Listener Query
Interval:
Enter the interval between the switch sends out MASQs.
Last Listener Query
Count:
Enter t
he number of MASQs that the switch sends before aging
out a multicast address when there is no MLD report response.

MLD Snooping Status
Description: Displays MLD Snooping status.
Member: Displays the member of the corresponding status.
Note:
1. Configurations of the Router Port Time and Member Port Time in 8.2.3 VLAN Config override
their global configurations here.
3. Before creating a Multicast VLAN, you should enable the MLD snooping function in this VLAN
in 8.2.3 VLAN Config.
Configuration Procedure of Multicast VLAN:
Step Operation Description
1
Create VLAN. Required. On the VLAN →802.1Q VLAN →VLAN Config
page, click the Create
button to create a VLAN. Enter the
VLAN ID and the description for the VLAN. Meanwhile,
specify its member ports.
2
Enable MLD Snooping
globally.
Required. On the Multicast →MLD Snooping →Global
Config page, enable the MLD Snooping function globally.
3
Enable MLD Snooping in the
VLAN.
Required. On the Multicast →MLD Snooping →VLAN
Config page, specify the VLAN ID as the VLAN created in
step 1.
4
Enable the Multicast VLAN. Required. On the Multicast →MLD Snooping →Multicast
page, enable the Multicast VLAN function and specify the
Multicast VLAN ID as the VLAN specified in Step 1.