TP-Link T2600G-28TS - Page 229

217
Choose the menu QoS→DiffServ→DSCP Priority to load the following page.
Figure 11-9 DSCP Priority
The following entries are displayed on this screen
:

DSCP Priority Config
DSCP Priority: Select Enable or Disable DSCP Priority.

Priority Level
Select:
Select the desired DSCP value for DSCP priority configuration. It
is multi-optional.
DSCP:
Indicates the priority determined by the DS region of IP datagram.
It ranges from 0 to 63.
Priority Level: Indicates the 802.1P priority t
he packets with tag are mapped to.
The priorities are labeled as CoS0 ~ CoS7.
Configuration Procedure:
Step Operation Description
1
Configure the mapping relation
between the DSCP priority and
802.1P priority
Required. On QoS→DiffServ→DSCP Priority
page,
enable DSCP Priority and configure
the mapping
relation between the DSCP priority and CoS.
2
Configure the mapping relation
between the CoS and the TC
Required. On QoS→DiffServ→802.1P Priority
page,
configure the mapping rela
tion between the CoS and
the TC.
3 Select a schedule mode
Required. On QoS→DiffServ→Schedule Mode
page,
select a schedule mode.