TP-Link T2600G-28TS - Page 285

273
Choose the menu Network Security→IP Source Guard to load the following page.
Figure 13-23 IP Source Guard
The following entries are displayed on this screen:

IP Source Guard Config
Select:
Select your desired port for configuration. It is multi-optional.
Port:
Displays the port number.
IPv4
Security Type: Select Security Type for the port.
• Disable: Select this option to disable the IP Sou
rce Guard
feature for the port.
• SIP+MAC:
Only the packets with its source IP address,
source MAC address and port number matched to the
IP-MAC binding rules can be processed.
IPv6
Security Type: Select Security Type for the port.
• Disable: Select this option to disable the IPv6
Source Guard
feature for the port.
• SIPv6+MAC: Only the packets with its source IPv6
address,
source MAC address and port number matched to the
IPv6-MAC binding rules can be processed.
LAG:
Displays the LAG to which the port belongs.
Note:
Before configuring IPv6 Security feature, you should configure the SDM template as
“enterpriseV6” and save your configurations. See SDM Template for more information about SDM
template configuration.