TP-Link T2600G-28TS - Page 296

284
Choose the menu Network Security→PPPoE→PPPoE ID Insertion to load the following page.
Figure 13-30 PPPoE Circuit-ID Config
The following entries are displayed on this screen:

Global Config
PPPoE ID Insertion: Enable/Disable the PPPoE Circuit-ID Insertion function globally.

Port Config
Port Select: Click the Select button to quick-
select the corresponding port
based on the port number you entered.
Select: Select the desired port for configuration. It is multi-optional.
Port: Displays the port number.
Circuit-ID: Enable/Disable the PPPoE Circuit-ID Insertion feature for the
port.
Circuit-ID Type: Specify the Circuit-ID type for the port:
• IP: The IP address of the switch will be used to encode the
Circuit-ID option. This is the default value.
• MAC: The MAC address of the switch will be used to encode
the Circuit-ID option.
• UDF: The user specified string with the maximum length of 40
characters will be used to encode the Circuit-ID option.
• UDF ONLY: Only the user specified string with the maximum
length of 40 will be used to encode the Circuit-ID option.
UDF Value: If the UDF is selected, specify a string with the maximum length
of 40 characters to encode the Circuit-id option.