TRENDnet TL2-G244 - Debug Ip Igmp Snooping

24-Port Gigabit Layer 2 Switch w/ 4 Shared Mini-GBIC Slots
32-8
User Guidelines Using no form the restart the snooping.
Example switch(config)#
shutdown snooping
Command History
Version
History
1.00.001
This command was introduced
debug ip igmp snooping
To enable the debug mode of IGMP snooping.
Command
debug ip igmp snooping {[init] [resources] [tmr] [src] [grp]
[qry] [vlan] [pkt] [fwd] [mgmt] [redundancy] | all }
no debug ip igmp snooping {[init] [resources] [tmr] [src] [grp]
[qry] [vlan] [pkt] [fwd] [mgmt] [redundancy] | all }
Syntax Description
init
Displays the initial and shudown debug message.
resources
Displays the system resources management debug
messages.
tmr
Displays the timer debug messages.
src
Displays the source debug messages.
grp
Displays the group debug messages.
qry
Displays the query related debug messages.
vlan
Displays the vlan debug messages.
pkt
Displays the packet dump debug messages.
fwd
Displays the L2 FDB related debug messages.
mgmt
Displays the management related debug messages.
redundancy
Displays the redundancy related debug messages.
all
Displays all debug messages.
Default Settings
Disable
Command Modes
Privileged EXEC Mode
User Guidelines
Usin no form to disable the debug mode.
Example
switch# debug ip igmp snooping all