TRENDnet TL2-G244 - RADIUS Server Configuration

24-Port Gigabit Layer 2 Switch w/ 4 Shared Mini-GBIC Slots
6-21
RADIUS Server Configuration
This page is to configure the details of RADIUS server.
Figure 58 – Layer2 Management > 802.1X > Radius Settings
Parameter
Description
Server ID
Specify the new RADIUS server ID. The possible ID is 1-10.
IP Address
Specify the IP address of the new RADIUS server.
Shared Secret
Specify the encryption key between RADIUS server and clients.
Server Type Specify the server type of the RADIUS server. The options are:
Authenticating – This server is only for RADIUS authentication.
Accounting - This server is only for RADIUS accounting.
Both - This RADIUS server support both authentication and accounting.
Response Time (secs)
Specify the time period that a client waits for the response from the RADIUS
server before re-sending the request. The possible number is 1-120 seconds.
Retry Count The maximum number that a client re-sends the request when there is no
response from RADIUS server. The possible number is 1-254 times.
Click Add to add a new RADIUS server, Reset to clear the value.
Parameter
Description
Select
Server ID
The RADIUS server ID.
IP Address
Specify the IP address of the RADIUS server.
Shared Secret
Specify the encryption key between RADIUS server and clients.
Server Type Specify the server type of the RADIUS server. The options are:
Authenticating – This server is only for RADIUS authentication.
Accounting - This server is only for RADIUS accounting.
Both - This RADIUS server support both authentication and accounting.
Response Time (secs) Specify the time period that a client waits for the response from the RADIUS
server before re-sending the request. The possible number is 1-120 seconds.
Retry Count The maximum number that a client re-sends the request when there is no
response from RADIUS server. The possible number is 1-254 times.
Click Apply to submit the changes the setting of an existing RADIUS server, Delete to delete one.