TRENDnet TL2-G244 - Default Restore-File; Default Vlan ID

24-Port Gigabit Layer 2 Switch w/ 4 Shared Mini-GBIC Slots
12-6
Command History Version History
1.00.001
This command was introduced.
default restore-file
To configure the default restoration file.
Command
default restore-file
<filename>
Syntax Description
filename The name of restoration file.
Default Settings
Iss.conf
Command Modes
Global Configuration Mode
User Guidelines
This command is to configure the default restoration file.
Example
switch(config)# default restore-file restore1.conf
Command History
Version History
1.00.001
This command was introduced.
Note
Default mode must be dynamic to make this command effective.
default vlan id
To configure the default VLAN ID.
Command
default vlan id <
count(1-4094)
>
Syntax Description count(1-4094) Change default VLAN from 1 to 4094.
Default Settings
1
Command Modes Global Configuration Mode
Example switch(config)#
default vlan id 100
Command History Version History
1.00.001
This command was introduced.