TRENDnet TL2-G244 - Default Mode; Default Restore

24-Port Gigabit Layer 2 Switch w/ 4 Shared Mini-GBIC Slots
12-5
Note
Default mode must be dynamic to make this command effective.
default mode
To configure the mode that the IP address of default interface is assigned.
Command
default mode { manual | dynamic }
Syntax Description
manual
Manual mode. The ip address of default interface is the one
configured by ‘default ip address’ command.
dynamic
Dynamic mode. The ip address of default interface is got
through the protocol configured by ‘default ip address
allocation protocol’ command.
Default Settings
Manual
Command Modes
Global Configuration Mode
User Guidelines
This command is to configure the mode that the IP address of default interface is
assigned.
Example
switch(config)# default mode dynamic
Command History
Version History
1.00.001
This command was introduced.
default restore
To enable or disable the default mode of configuration restoration.
Command
default restore {enable | disable}
Syntax Description
enable
To enable the configuration restoration option.
disable
To disable the configuration restoration.
Default Settings Disable
Command Modes
Global Configuration Mode
User Guidelines This command is to adjust the default mode of configuration restoration.
Example switch(config)#
default restore enable