TRENDnet TL2-G244 - Show Rate-Limit

24-Port Gigabit Layer 2 Switch w/ 4 Shared Mini-GBIC Slots
38-2
Command Modes Interface Configuration Mode
User Guidelines The no form is to disable the rate limiting on a port.
Example
switch(config-if)# rate-limit ingress 64
Command History Version History
1.00.001
This command was introduced
show rate-limit
To display the current rate-limit setting of interfaces
Command
show rate-limit [ interface
<interface-type> <interface-id>
]
Syntax Description
interface
interface-type
interface-id
Specifying which interface to show rate limiting information.
Interface-type including Fa (Fast Ethernet) or Gi (Gigabit
Ethernet).
Interface-id is slot/port number.
Command Modes
Privileged EXEC Mode
User Guidelines
System will show the information for all ports when executing the command
without a given interface parameter.
Example
switch# show rate-limit int fa 0/1
Fa0/1
Ingress Rate Limit Control : Disabled
Egress Rate Limit Control : Enabled
Egress Rate Limit Control : 64
Command History
Version History
1.00.001
This command was introduced