TSI Instruments 3080 Series

Using Serial Data Commands C–11
Set Calibration Bypass Parameter B
(Polynomial Flow Calibration Algorithm)
SCBBx (Set Calibration Bypass B Parameter)
Set sheath flow calibration parameter:
SCBB1.234567e-12 Set: bypass flow calibration parameter
SCBB Return: bypass flow calibration parameter
Set Calibration Impactor Parameter A
(Polynomial Flow Calibration Algorithm)
SCIxAy (Set Calibration Impactor Parameter A)
Set impactor flow calibration parameter A (x can be 1, 2,
or 3; corresponding to 0.457, 0.508 and 0.071 nozzles):
SCI1A1.234567e-12 Set: impactor flow calibration parameter
1 A
SCI1A Return: impactor flow calibration parameter
1 A
Set Calibration Impactor Parameter B
(Polynomial Flow Calibration Algorithm)
SCIxBy (Set Calibration Impactor Parameter B)
Set impactor flow calibration parameter B (x can be 1, 2,
or 3; corresponding to 0.457, 0.508 and 0.071 nozzles):
SCI1B1.234567e-12 Set: impactor flow calibration parameter
1 B
SCI1B Return: impactor flow calibration parameter
1 B
Set Auxiliary Output
SAOx (Set Auxiliary Output)
SAO0 Set: auxiliary output to [x = 0: 0 volt, x = 1: 5 volt
SAO Return: auxiliary input status (0: 0 volt, 1: 5 volt)