Operating
Using the USB host port
112
Hans Turck GmbH & Co. KG | T +49 208 4952-0 | F +49 208 4952-264 | more@turck.com | www.turck.com
Perform firmware update (function FW_UPDATE)
Create the folder FW_UPDATE on a USB stick.
Store the firmware as bin file in the folder FW_UPDATE.
Insert the USB stick into the device.
a The RUN-LED flashes green with 0.5 Hz.
Press the SET-button within the next 30 seconds for at least 3 seconds.
a The RUN LED flashes in the sequence 3 × green - pause (1 Hz) - 3 × green - pause (1 Hz)
- ....
a The data is loaded into the device.
a When the RUN LED blinks orange at 1 Hz, the firmware update is complete.
Remove the USB stick.
Execute a power cycle.
a The device restarts.
Write user data to the device (function USB_DATA_WRITE)
Insert the USB stick with the USB_DATA_WRITE folder into the device.
a The RUN-LED flashes green with 0.5 Hz.
Press the SET-button within the next 30 seconds for at least 3 seconds.
a The RUN-LED flashes green with 2 Hz.
a The data are stored to the device.
a When the RUN LED blinks orange at 1 Hz, the data has been successfully saved.
Remove the USB stick.
a The device restarts.
To Next Page
Loading...
