turck TBEN-L Series Instructions For Use

Product Description
Functions and operating modes
14
Hans Turck GmbH & Co. KG | T +49 208 4952-0 | F +49 208 4952-264 | more@turck.com | www.turck.com
NOTE
The functions PROFINET device and EtherNet/IP™ slave are only available at Ethernet
port P1 (in CODESYS at eth0).
Possible combinations Master/Slave
The following table is valid for combinations of one Master and one Slave.
Modbus TCP
Slave
PROFINET
Device
EtherNet/IP™
Device
Modbus RTU
Slave
CANopen
Device
Modbus TCP Master x x x x x
PROFINET Controller x x* x x x
EtherNet/IP™ Scanner x x x* x x
Modbus RTU Master x x x x* x
CANopen Manager x x x x -
SAE J1939 Manager x x x x -
* These functions cannot be used together on the same Ethernet port (Dual MAC Mode) or
COM port. Each function must be configured separately on an Ethernet or COM port.
Possible combinations Master/Master
Modbus
TCP
Master
PROFINET
Controller
EtherNet/
IP™
Scanner
Modbus
RTU
Master
CANopen
Manager
SAE J1939
Manager
Modbus TCP Master - x x x x x
PROFINET Control-
ler
x - - x x x
EtherNet/IP™ Scan-
ner
x - - x x x
Modbus RTU Master x x x (1 Master
per COM
port)
x x
CANopen Manager x x x x - -
SAE J1939 Manager x x x x - -
Possible combinations Slave/Slave
Modbus TCP
Slave
PROFINET
Device
EtherNet/IP™
Device
Modbus RTU
Slave
CANopen
Device
Modbus TCP Slave - x x x x
PROFINET Device x - x x x
EtherNet/IP™ Device x x - x x
Modbus RTU Slave x x x
(1 Slave per
COM port)
x
CANopen Device x x x x -

turck TBEN-L Series Specifications

General

Brand	turck
Model	TBEN-L Series
Category	I/O Systems
Language	English