189
189
Restoring the Motorcycle to Use
• Take the motorcycle out of garage and clean the
motorcycle thoroughly (refer page 187).
• Remount the battery after bench charging if
required.
• Fill the engine oil and check the oil level using the
gauge.
• Lubricate the necessary parts.
• Fill up fresh fuel in the fuel tank (refer page 123).
• Check and inflate the tyre pressure to the
specified limit.
• Check and correct the points mentioned in
pre-ride check (refer page 132).
Turn on the ignition and start the engine. Allow the to run
in idle mode for few minutes and ride out.
Note
To Next Page
Loading...
