38
Switch Assembly RH (ref. Fig. 18)
Switch assembly RH is located in the handle bar
at RH side and has the switch electric starter cum
engine kill switch in it.
Do not operate the kill switch when riding else you may
fall due to rear wheel locking.
This switch is mainly intended for use in emergencies
when you need to stop the engine quickly.
If the electric starter switch is pressed more than
3 seconds continuously, the starter motor gets disabled
automatically and will not crank the engine. The motor
cranks the engine only after 1 second or if the switch is
released and repressed again.
Please remember that the electric starter function will
work only when the throttle opening is less than 30%.
Release the electric starter switch immediately after
engine starts.
Fig. 18
The operation of integrated electric starter cum
engine kill switch is explained below:
• The engine kill switch is used to switch off the
engine but to keep other DC system active.
Press the switch towards ‘ ’ to turn ‘ON’ the
engine kill switch. The ignition circuit is disabled,
preventing the engine from being started. To
restart the engine, return the switch to the ‘ ’
position.
• To start the engine press the switch to ‘ ’
position. Ensure that the transmission is in
neutral or else by pressing the clutch lever before
engaging the starter switch.
To Next Page
Loading...
