SECTION 3. SEPARATION OF MAJOR COMPONENTS
1. SEPARATION OF THE FRONT AXLE ASSEMBLY AND THE AXLE BRACKET
Parts which can be inspected during this operation
-Final case -Differential gear -Power steering system
(1) Removal
1) Hold the front hitch or the front bracket
securely with a crane or stands.
2) Support the front axle bracket with a jack
3) Remove steering hose(LH, RH) to the
power cylinder.
Fig.2-5 Front axle
Note : When working on the 4WD version,
the drive shaft should be removed
ahead of time.
(2) Installation
1) Install the front axle assembly.
2) Install four bolts connecting the front axle
supports with the front axle bracket.
Note : Apply grease on the bushing with grease
ahead of time.
3) Install both of the right and the left steering
hose.
4) Install the drive shaft (4WD)
Fig.2-4 Steering hose (LH, RH)
4) Remove four bolts connecting the front axle
supports with the front axle bracket
5) Remove the front axle assembly forward.
Fig.2-6 Drive shaft (4WD)
2-5
Note : When reassembling the parts related to the
front axle assembly. Apply grease to
the oil seal with grease ahead of time.
Install the oil seal carefully not to allow its
lips to turn over.
Front bolts
Rear bolts
To Next Page
Loading...
Need help?
General
