(3) INSTALLATION
REASSEMBLY IN REVERSE ORDER OF REMOVAL.
1) Install the engine on the front axle bracket.
2) Assemble the engine and the transmission assembly.
Note : Apply adhesive (THREE BOND 1215) to the contact surfaces of the front transmission case
and the housing of engine side ahead of time.
Note : Apply small mount of grease (THREE BOND 1901) to each of the sliding parts. Be careful not to
apply excessive amount of grease as this could cause clutch slipping. During operation, be sure
to avoid any of the reassembly operations that may place load upon the input gear.
3) Install the quick coupler of the freezer.
4) Install the power steering hose
5) Install the hydraulic system piping.
6) Connect the wiring for the engine.
7) Connect the other wirings.
8) Install the accelerator wire.
9) Connect the battery terminals.
10) Install the engine hood and side cover.
(2) Engine separation from the front axle bracket
When separating the engine from the chassis, the following steps are required as well as the ones
mentioned below.
1) Lift the engine with the hoist and hold the front axle bracket with a stands or the like.
2) Disconnect the upper, Lower, and drain hoses from the radiator.
3) Disconnect the three power steering system hoses (Reference)
4) Remove the fuel hose and the drain hose (Reference)
5) Disconnect the hydraulic line (Reference)
6) Remove the Air-conditioner system and the wiring
7) Separate the engine from the front axle bracket.
8) Wedge both sides of the front axle to prevent the engine from tilting.
Fig.2-28 Wedging
2-11
To Next Page
Loading...
Need help?
General
