u-blox ANTARIS 4 - Page 146


your position is our focus
My application (e.g. u-center AE) does not receive anything
Check ifthe evaluationbox ispoweredand make sure theserial cable isproperly connectedto theevaluation
valuationboxwilloutputUBXprotocolonport1at57600baud.
My application (e.g. u-center AE) d eive a me
M udrateissufficient.If drateis
suf eiversbasedontheANTARIS
®
GPS
Technology willskipexcessivemessages.
S port cards/adapters (i.e. US 232 con erte  generate errors. If a communication
e rswhileu-centerreceivesame ,themes willbediscarded.
) looses the connection to the GPS receiver
The ANTARIS
®
 GPS Technology and u-center have an autobauding feature. If frequent communication errors
ith the serial port), the connection may be lost since u-center AE and the GPS
r lautonomouslytrytoad te. ot enterAEautobaudingfeatureif
the
G rhastheautobaudingflag
S ports are not shown in th rt list of m p E)
Only  ports, that are availabl  computer, will  port drop down list. If a
C gray,anotherapplicationrun gonthisco put it.
P ’t behave as expected
aserefertotheANTARIS
®
EvalKit - Users Guideformoreinformation.


boxandthePC.Bydefault,thee
oes not rec ll ssages
akesuretheba thebau
in ficient,GPSrec
ome serial B to RS v r) frequently
rroroccu ssage sage
My application (e.g. u-center AE
occur (i.e. due to problems w
eceiverwil justthebaudra Don enabletheu-c
PSreceive enabled.
ome COM e po y a plication (e.g. u-center A
 the COM
is
e on ur yo  show up in the COM
OMPort nin m erisusing
The G S receiver EvalKit doesn
Ple
GPSModules-SystemIntegrationManual(SIM)(incl.ReferenceDesign) Troubleshooting
GPS.G4-MS4-05007-A1
  Page 146