u-blox ANTARIS 4 - Default Settings; Antenna Configuration (UBX - CFG - ANT)


your position is our focus
A Default Settings
 Note For the default settings for the ROM-only - Low Cost GPS receivers please refer as well to
uration settings are defined by the status of the GPSMODE Pins at the
ware
Anten FG – ANT)
gr
Section 4.8.2 as the config
startup.
A.1 Hard
na Configuration (UBX – C
Pro ammable GPS Receivers (LEA-4H, LEA-4P, TIM-4H and TIM-4P)
Parameter Default setting Unit Range/Remark
Enabl
Enabledabled-Disabled
e Control Signal
En
Enable Short Circuit Detecti
Enabled -Disabled
on
Enabled
Enabl Down
ic
Enabledabled-Disabled
e Short Circuit Power
log
En
Enable Automat
Re
ic Short Circuit
ery cov
Disabled -DisabledEnabled
Enabl ction
Disabledabled-Disabled
e Open circuit dete
En
Table 5 s
C 4S, LEA-4M
19
, TIM-4A, -4S and S
6: Antenna setting
Low ost (ROM only) GPS Receivers (LEA-4A, LEA- TIM NEO-4 )
Parameter Default setting Unit Range/Remark
Enabl
Enabledabled-Disabled
e Control Signal
En
Enabl ion
Enabledabled-Disabled
e Short Circuit Detect
En
Enable Short Cir
logi
cuit Power Down
c
Enabled -DisabledEnabled
Enabl rcuit
Recovery
Disabledabled-Disabled
e Automatic Short Ci
En
Enabl
Enabledabled-Disabled
e Open circuit detection
En
Table 5
A.2 Navigation
Datum
7: Antenna settings
(UBX – CFG – DAT)
Parameter Default setting Unit Range/Remark
Datum
0–WGS84fertoAppendix B Re
Table 5 ttings
 
8: Datum default se
  
19
Pleaserefertosection4.3.3.2formoreinformationaboutNEO-4SandLEA-4M
GPSModules-SystemIntegrationManual(SIM)(incl.ReferenceDesign) DefaultSettings
GPS.G4-MS4-05007-A1
  Page 147