UAV-1004234-001, AV-30-E Installation Manual 85
Rev H
• Put the autopilot into SkyView mode by pressing and releasing the
Mode button
corner if the autopilot is receiving data from the AV-30.
• Verify that the autopilot display is the same as the selected
altitudeon the AV-30.
• On the AV-30, change the and verify that the changed
value appears on the
•
on the AV-30.
• On the AV-30, change the Set VS and verify that the
•
bug G on the AV-30.
• On the AV-30, change the heading bug and verify that the
changed value appears on the autopilot display
• On the autopilot, if using an AEROCRUZE, exit SkyView mode by
pressing and releasing the Mode button
•
Pro Pilot verification steps
• On the AV-30, rotate the center knob to vary the barometric
correction and verify that the Pro Pilot ELEVATION (ALTITUDE)
set screen displays a setting that varies as the AV-30 barometric
correction is varied.
• On the AV-
•
on the AV-30.
•
-30.
• On the AV-30, change the heading bug and verify that the
To Next Page
