68 Enhanced phone functions
Send trunk flash
To activate ISDN-type services and features through the network carrier’s ana-
log trunks or those of other communications platforms (such as "consultation
hold"), you must send a signal to the trunks before dialing the service code or
telephone number.
Prerequisite: You have set up an external connection.
@ Press the menu key. page 25.
Select using the Softkey.
Select using the Softkey.
Select using the Softkey and confirm the option shown
1
.
j Enter the service code and/or telephone number.
If you cannot reach a destination
Call waiting (camp-on)
Prerequisite: You have dialed an internal number and hear a busy signal. It is
important that you reach the called party.
Wait (approx. 5 seconds) until "Camp-on" appears on the display and the busy
tone is followed by the ring tone.
The called party can then respond page 61.
Busy override – joining a call in progress
This function is only available if it has been configured by the service technician
(contact your service personnel).
Prerequisite: You have dialed an internal number and hear a busy signal. It is
important that you reach the called party.
Select and confirm the option shown.
The called party and person to whom this party is talking hear an alerting tone
every two seconds.
If the called party has a system telephone with display, the following appears on
the screen: "Override: (Number or name)".
You can now start talking.
Program/Service g
Calls g
Trunk flash
1.
Camp-on
The called party can prevent automatic call waiting page 62.
If this feature is configured (contact your service personnel), you will hear
the ring tone and the message "Camp-on" is immediately displayed.
Override
To Next Page
Loading...
Need help?
General