Unify OpenScape HiPath 4000 - Basic Functions; Answering a Call; Answering a Call Via the Handset; Answering a Call Via the Loudspeaker (Speakerphone Mode)

Basic functions 19
Basic functions
Answering a call
Answering a call via the handset
The phone rings. The caller is displayed.
^ Lift the handset.
if nec. + or - Set the call volume.
Answering a call via the loudspeaker
(speakerphone mode)
The phone rings. The caller is displayed.
n Press the key shown. The LED lights up.
The speakerphone function is activated.
if nec. + or - Set the call volume.
Suggestions for using speakerphone mode:
• Tell the other party that speakerphone mode is active.
• Adjust the call volume while speakerphone mode is active.
• The ideal distance between the user and the phone in speakerphone mode is
50 cm.
Accepting calls via the headset
Prerequisite: A headset is connected.
The phone rings. The o key flashes.
o Press the key shown.
if nec. + or - Set the call volume.
Please read the introductory chapter "Getting to know your OpenStage
phone"
 Page 12 carefully before performing any of the steps described
here on your phone.
An incoming call will cancel any ongoing telephone setting operations.
The headset port on the phone is preset for a corded device and is auto-
matically switched when you use a cordless headset. You must however
use the "call answer" function of the headset at least once so that the tele-
phone can make the corresponding setting.