Unify OpenScape HiPath 4000 - Using Call Forwarding; Automatically Forwarding Calls; Delayed Call Forwarding

Enhanced phone functions 49
Using call forwarding
Automatically forwarding calls
The administrator can configure different call forwarding settings in the system
for internal and external calls and activate these settings for your station. The
following calls may be forwarded
• All calls without restriction
• Calls on busy
• Calls on no reply
Forwarding for all calls without restriction should only be configure if the station
is only used for outgoing calls (e.g.
in an elevator).
If you have configured fixed or variable forwarding and the manual forwarding
destinations are not reachable (e.g.
busy), calls are automatically forwarded to
system forwarding destinations.
Delayed call forwarding
This forwarding type can be configured for initial and/or second calls.
Initial call
Prerequisite: "Forwarding. no reply" is activated  Page 24,
The caller hears the ring tone and is only forwarded to another station once a set
time (
 Page 27) has elapsed.
Second call
Prerequisite: Second call  Page 35 and "Forwarding on busy/no reply" or
"Forwarding. no reply" are activated  Page 24.
You automatically receive a call waiting tone and information about the caller
with an incoming second call. You then have the option of accepting this call be
-
fore call forwarding is activated (e.g. if you are waiting for an urgent call).
Please note the description for programming call forwarding  Page 24.