Unify OpenScape HiPath 4000 - Additional Forwarding Types

Basic functions 27
Deactivating variable call forwarding
r Press the lit key. The LED goes out.
or
: Open the idle menu  Page 16.
Select and confirm the option shown.
Call forwarding is deactivated. The destination number is deleted.
Additional forwarding types
This description applies for the following forwarding types:
• Forwarding for intnl
• Forwarding for extnl
• Forwarding on busy
• Call forward. no reply
• Forwarding on busy/no reply
Programming a forwarding destination activates call forwarding. If call forward-
ing is deactivated, the forwarding destination is deleted at the same time.
Configuring and activating call forwarding
N Open the Program/Service menu  Page 18.
Confirm the option shown.
Confirm the option shown.
Variable call forwarding is offered first.
Confirm until the required forwarding type  Page 24 is shown in the first line.
Example of "Call forward. no reply"
Forwarding type with status.
Select and confirm the option shown.
j Enter the call forwarding destination number.
Confirm, when the phone number is complete. The status is set to "FWD-VAR-
RNA-BOTH on".
Select and confirm the option shown if you want to change the 0 seconds pref-
erence.
Confirm the option shown.
j Enter the time in seconds after which the call should be forwarded. You can en-
ter a maximum of 60 seconds. If the value is, the system forwarding time is used
. The time set here is also used by the "Forwarding on busy/no reply" forwarding
type.
Confirm the option shown.
If you enter a cross-system number, you must complete your entry by
pressing (.
Deact call forwarding?
Destinations?
Call forwarding?
Next forwarding type?
FWD-VAR-RNA-BOTH off
Enter destination:
Save?
Ringing duration until forwarding
Modify?
Save?