Enhanced phone functions 45
HiPath 4000 as an entrance telephone
system (two-way intercom)
You can place a speaker call to an internal party on HiPath 4000 using the loud-
speaker on their telephone to establish a connection. You can initiate a speaker
call from a consultation call. The following functions are available:
• System-wide speaker call
– to a variable destination
– to a fixed destination
• Speaker call in a group
– to a variable destination
– to a fixed destination
• Two-way intercom in a group
– to a variable destination
– to a fixed destination
• Announcement to all members of a line trunk group
You can cancel the speaker call or the announcement by replacing the handset
or, during a consultation call, by retrieving the call on hold.
System-wide speaker call
You can place a speaker call from your phone to any internal party with a tele-
phone equipped with speakerphone mode or a loudspeaker.
Speaker call to a variable destination
The destination party is contacted via their internal phone number.
^ Lift the handset.
or
n Press the key and enter speakerphone mode.
j Enter the system code for "Speaker call-one-way" (contact the administrator if
necessary).
or
S Press the programmed "Spkr. 1-way" key.
j Enter the internal number of the party.
A connection is immediately established to this destination station’s loudspeaker
if
• the station is not busy
• the handset has not been lifted
• "Speaker call protect" is not activated
Z The caller hears a confirmation tone when the connection is established and
they are free to start speaking.
^ The called party can accept the connection by lifting the handset.
Please ensure for all functions that "Speaker call protect" is deactivated on
the relevant phones
Page 64.
If a speaker call is placed to a party and "Speaker call protect" is activated
on their phone, the speaker call is ignored and a normal call is established.
To Next Page
Loading...
