Unify OpenScape HiPath 4000 - Holding a Call on the Trunk Key; Saved Number Redial for a Specific Line; Last Number Dialed for a Specific Line

Making calls via multiple lines 73
Holding a call on the trunk key
Prerequisite: The "Hold" key is programmed on your telephone.
S Press the "Hold" key.
The trunk key LED is flashing slowly.
Saved number redial for a specific line
If this type of saved number redial is configured on your system, you can save
a phone number for subsequent redial on a particular line
 Page 74. The saved
phone number is dialed using the line key and the saved number redial key.
^ Lift the handset.
or
n Press the key shown.
Display.
S Press the applicable line key. The LED lights up.
Select and confirm the option shown.
Last number dialed for a specific line
The last phone number dialed via your primary line is saved.
If this type of saved number redial is configured on your system, every last num-
ber dialed for the current line is automatically saved for redial.
^ Lift the handset.
or
n Press the key and enter speakerphone mode.
S Press the required line key. The LED lights up.
Confirm the option shown.
^ Lift the handset.
or
n Press the key and enter speakerphone mode.
Your HiPath 4000 system can also be configured, so the call is held by
pressing the trunk key. Please test this or, if necessary, ask your adminis-
trator.
Please select a line
Saved number redial?
If you save a redial on a specific line, this can be overwritten by another
team member.
Last number redial?