Unify OpenScape HiPath 4000 - Identifying the Line Used; Making Calls on Multiple Lines Alternately

Making calls via multiple lines 75
Deleting mailbox entries
The relevant entry is displayed.
Select and confirm the option shown.
Ending message retrieval
N Press the key shown.
or
Select and confirm the option shown.
Undeleted entries in the mailbox remain saved. If unanswered callback requests
are present, the "MBLN" programmed function key remains illuminated.
Identifying the line used
If several lines are occupied at the same time, you can determine which one you
are currently using for a call.
With a programmed function key
S Press the "Line in Use" programmed function key.
Via the menu
N Open the Program/Service menu  Page 18.
Select and confirm the option shown.
Select and confirm the option shown.
The line number and status of the line currently in use are displayed.
Making calls on multiple lines alternately
Prerequisite 1: The administrator have specified that when you change lines,
the lines are hold and can only be disconnected by replacing the handset or
pressing the release key.
Prerequisite 2: You are connected to multiple parties via two or more lines.
These may be callers (
 Page 71) or called parties ( Page 72).
You are making a call, for example, on line 1. The line key of the station on hold
blinks slowly.
T Press the flashing line key 2. The first call party is on hold on line 1.
T Press the flashing line key 1. The second call party is on hold on line 2.
You can switch between lines as often as you wish.
Delete?
Cancel?
More features?
Show used line?