Unify OpenScape HiPath 4000 - Speaker Call in a Group

46 Enhanced phone functions
n or S If the called party presses the speaker key or the line key (if configured), the con-
nection is lost.
Speaker call to a fixed destination
The system code for "Speaker call-one-way" and the destination number are
programmed on a repdial key
 Page 57.
S Press the programmed repdial key. A connection to the destination loudspeaker
is immediately established.
Speaker call in a group
You can also establish a normal connection within a group or team (with team
call = speed dial numbers 0-9 or 00-99 for team members) via a speaker call.
The speaker call is then initiated by a group telephone.
Speaker call to a variable destination
^ Lift the handset.
or
n Press the key and enter speakerphone mode.
j Enter the system code for "COM group speaker call" (contact the administrator
if necessary).
or
S Press the programmed key for "COM Group".
j Enter the speed dial number for the corresponding group member.
A connection is immediately established to this destination station’s loudspeaker
if
• the station is not busy
• the handset has not been lifted
• "Do not disturb" is not activated
^ The called party accepts the DSS call by lifting the handset.
n or S If the called party presses the speaker key or the line key (if configured), the con-
nection is lost.
Speaker call to a fixed destination
The system code for "COM group speaker call" and the speed dial number for
the corresponding group member are programmed on a repdial key
 Page 57.
S Press the programmed repdial key. A connection to the destination loudspeaker
is immediately established.
^ The called party can accept the connection by lifting the handset.
n or S If the called party presses the speaker key or the line key (if configured), the con-
nection is lost.
The same number of speaker calls and normal connections is possible.
The "COM group speaker call" function is line-independent - all phones
can call each other via a speaker call.