Default Setting (System Menu)
8-16
Original Orientation
Set the original orientation defaults. The available default settings are shown below.
Refer to page 4-9 for Original Orientation.
Use the procedure below to select the default orientation when originals are placed on the platen.
1 Press the System Menu key.
2 Press [Common Settings], [ ], [Next] of Function Defaults and then [Change] of Original Orientation.
3 Select [Top Edge Top] or [Top Edge Left] for the default.
4 Press [OK].
Continuous Scan
Set the continuous scan defaults. The available default settings are shown below.
Refer to page 4-9 for Original Orientation.
Use the procedure below to select the default settings for continuous scanning.
1 Press the System Menu key.
2 Press [Common Settings], [ ], [Next] of Function Defaults and then [Change] of Continuous Scan.
3 Select [Off] or [On] for the default.
Use the procedure below to select the default quality setting for originals.
4 Press [OK].
Item Description
Top Edge Top Select the original's top edge at the top.
Top Edge Left Select the original's top edge at the left.
Item Description
Off Continuous scan not performed
On Continuous scan performed
To Next Page
Loading...
Need help?
General
