Default Setting (System Menu)
8-21
8
1 Press the System Menu key.
2 Press [Common Settings], [ ], [Next] of Function Defaults, [ ], and then [Change] of E-mail Subject/Body.
3 Press [Subject] to enter an E-mail subject not more than 60 characters.
NOTE: Refer to the Character Entry Method on page Appendix-7 for details on entering characters.
4 Press [OK].
5 Press [Body] to enter an E-mail Body not more than 500 characters.
6 Press [OK].
7 Check that the entries are correct and press [OK].
Border Erase Default
Set the default width to be erased as a border. The table below shows the measurement ranges that can be set.
NOTE: Refer to page 4-16 and page 5-23 for Border Erase.
Use the procedure below to set the default border erase width.
1 Press the System Menu key.
2 Press [Common Settings], [ ], [Next] of Function Defaults, [ ] and then [Change] of Border Erase Default.
3 Press [+] or [–] for the Border and Gutter width to erase.
You can use the numeric keys to enter the number directly.
4 Press [OK].
Border Erase to Back Page
Select the Border Erase Method for Back Page of a sheet. The table below shows the available settings.
NOTE: Refer to page 4-16 and page 5-23 for Border Erase.
Use the procedure below to specify the border erase setting for the back of the page.
Input units Range
Inch 0 to 2" (in 0.01" increments)
Metric 0 mm to 50 mm (in 1 mm increments)
Item Description
Same as Front Page Border Erase performed in the same setting as the front page
Do Not Erase No Border Erase performed on the back page
To Next Page
Loading...
Need help?
General
